Take all the power out, AC power and the batteries 3. Write down the original switch positions 2. I did mentioned to him about the X, Y, Z dip switches. I'll go c him tomorrow if i can follow the steps. Appearently, he did follow the procedure but still doesn't work. This happened to my friend before 5 yrs ago but i was able to fix it by finding an initialization procedure for the DRO and performed the same. The Futaba display amount does not match the table movement. My friend has the same problem as stated by this forum member. I sent back the older box and kept the newer one, it has a much brighter display and the button membrane is in much better shape anyways. #FUTABA PULSCALE CJ 2004 MANUAL HOW TO#The trouble was that I couldn't find a manual nor anyone that knew how to set it. I'm sure that when they unplugged it, it lost all the settings. They were very corroded so they were obviously more than 6 months old. And it then also made sense why the first box failed and why it must have been a setup issue - the back of the box said to replace the batteries every 6 months. I could set both the resolution, and the maximum number of decimal places that would show up on the readout. The X0 and Y0 were all off, but the X1 and Y1 had an identical sequence of on and off positions. The older box didn't have any switches, and I pushed all kinds of button combinations at random, nothing worked.īut the newer one had 4 sets of dip switches inside labeled X0, X1, Y0, and Y1. I finally found someone that worked on them that said there were either a special sequence of buttons to push to get it into setup mode, or possibly some dip switches on the mainboard in the box. The seller sent me a newer model second box, but it was also a Futaba, and also had the same problem. Similar Threads: ĭid you set the resolution to match the scale?Yeah, I finally got it. I can zero it out, but it won't read thousandths. It's acting like it's displaying mm, but it's set in inch mode. Here's my problem, and I've tried it on mm mode, inch mode, and it doesn't make any difference - every full turn of the handle, either x or y should be.200' on the DRO, but it's only.080'. I'm trying to find someone with a manual, or at least a picture of the face that's clear enough to read the buttons, or even someone that uses one. It has no manual and some of the button faces are missing. Konverter edinic izmereniya programma mp3. Futaba Pulscale Digital Readout Photos And Descriptions. Futaba Pulscale Digital Readout Best Photos And Description. #FUTABA PULSCALE CJ 2004 MANUAL MANUALS#Futaba Pulscale Dro Manuals 6,6/10 3887 reviews
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |